If you notice that your IconBit NetTAB Mercury Duo NT-3502M hangs, stays frozen or "thinking" for a long time, it does not react, perhaps because it is overloaded and you have thought about restarting quickly to free up its 1 GB RAM memory, in just three steps we will indicate you how to restart it.
A restart does not erase any data, it only consists of turning the device off and on again, if you want to erase all the content and restore the factory, consult the following tutorial: How to restore a IconBit NetTAB Mercury Duo NT-3502M.
Before restarting, you must bear in mind that you must know the PIN code of the SIM card and the unlock pattern or password of the NetTAB Mercury Duo NT-3502M, since it will request it when it is turned on again.
Table of Contents:
Estimated time: 2 minutes.
1- First step:
Press and hold the power or unlock button on the IconBit NetTAB Mercury Duo NT-3502M until a screen with various options appears.
2- Second step:
Among the options that are displayed on the screen of the IconBit NetTAB Mercury Duo NT-3502M, choose "Restart". If a confirmation message appears, press accept.
3- Third step:
The device will turn off and on again to perform the reboot, wait a few seconds or minutes. When it is turned on again, it will request the PIN code of the SIM card and the pattern, fingerprint or unlock code.
1- First step:
First of all, display the quick access or settings bar of your IconBit NetTAB Mercury Duo NT-3502M. To do this, with the IconBit NetTAB Mercury Duo NT-3502M unlocked, you can slide your finger from the top of the screen downwards, the shortcuts to device settings will be displayed.
2- Second step:
Swipe a second time to fully display the shortcuts panel. You will see in the lower right part a button with the symbol to turn on / off, click on this button to continue.
3- Third step:
Several options will be displayed on the IconBit NetTAB Mercury Duo NT-3502M screen, including activating emergency mode, power off and the option you are looking for: "Restart". Click on the "Restart" button to continue.
If you cannot restart the IconBit NetTAB Mercury Duo NT-3502M since it is blocked and the previous method does not work, you must proceed to turn it off and turn it on again using the physical buttons.
To force a restart on your NetTAB Mercury Duo NT-3502M press and hold the power button (or unlock button) for at least 8 seconds until the IconBit or Android logo appears on the screen and release the button while it turns on again.
If the device still does not respond and you cannot restart it, it is possible that it is low on enough battery, in that case connect the NetTAB Mercury Duo NT-3502M to its charger and try the procedure again.
If it continues without responding and does not turn on or has entered a loop, it is possible that some internal component such as the motherboard, memory, screen or even the power button has been damaged so you will have to repair it or resort to the warranty.
There are no questions yet about "How to restart IconBit NetTAB Mercury Duo NT-3502M - Soft reset"; you can write the first one.