Hard reset Videocon Graphite 1 V45ED
How to hard reset or fully wipe Videocon Graphite 1 V45ED
If your Videocon Graphite 1 V45ED does not turn on, it does not react, it shows an error message when it turns on or you want to sell it, give it away or take it in for repair and you want to make sure that all the content stored in its 8 GB (gigabytes) internal memory is erased, you will have to force its restoration.
Forcing the restore or doing a “hard reset” is a drastic method that can be used when the Graphite 1 V45ED settings cannot be accessed either because the password has been forgotten or the operating system is corrupted.
If you can access the settings of your Graphite 1 V45ED and want to perform a restore, it is preferable to do so using the “Reset” method, otherwise continue reading to see step by step how to force the reset, format or do a “hard reset”.
This procedure erases all the content stored on the Graphite 1 V45ED so if possible, you should make a backup copy of your data before proceeding and unlink the Google account.
Estimated time: 5 minutes.
1- First step:
First of all, turn off your Videocon Graphite 1 V45ED completely. If you can't unlock the screen, press and hold the power button for about 20 seconds and the phone will turn off.
2- Second step:
Simultaneously press the power key and the volume key down on the Videocon Graphite 1 V45ED for a few seconds. On some devices, depending on the Android version, the combination may be the power key and the volume key up.
3- Third step:
When the Videocon logo is displayed, release the buttons. In the following menu, the touch screen does not work, so you must move through the menu with the volume up and volume down keys until you reach the option "Wipe data/factory reset" and press the power button to access it.
This menu is usually displayed in English, if the device menu appears in Chinese characters, see how to reset a mobile in Chinese.
4- Fourth step:
A warning message will appear to avoid hard reset the Videocon Graphite 1 V45ED by mistake. Use the Volume Up and Volume Down keys to select the "Yes" option and press the Power button to activate the option.
5- Fifth step:
After a few seconds, the formatting and deletion of all data from the Videocon Graphite 1 V45ED will have been carried out, returning to its factory state, now it is necessary to restart the Graphite 1 V45ED so using the volume up and volume down buttons, move to the option "Reboot system now" and press the power button to proceed to the restart.
Keep in mind that depending on the country, model and firmware updates of the Videocon Graphite 1 V45ED, the procedure may be slightly different.
If you have had problems performing a forced restore of the Graphite 1 V45ED , consult the following articles with frequent problems that appear below, if you cannot find a solution to your problem, consult the section “Frequently Asked Questions about Videocon Graphite 1 V45ED” and leave your comment so that we can consult it and offer better service.
